*Cutting with the double straight knife, it is especially suitable for the segmentation of precision SMD sheet and aluminum PCB.
*With guilotine operation, it applies to PCB of all kinds of thickness, whose board schedule is less than 1-2mm, so there is no concerns about safety.
*The inner stress when cutting will be under 180uE, in case of a soder crack and the damage of precision components.
*The minimum width between the edge of V-groove and the parts is 0.3mm, and the maximum up and down height is 40mm.
*the cutting rate is one segmentation for one second, controlled by pneumatic pedal switch.
*the starting of the cutting set is for passive, so that the cutting tangent and position is under secure control. With little stress when cutting, there will no soder crack.
* With cutting of nonroller (circular knife, straight knife ) type, there is no dust, no motor drive, and no carbon powder pollution.
*With no-rubbing type cutting, there is no metal residue.
* The blade can be used 600000/times without power supply, avoiding the loss and change of electrical products.
*The pcb separator depaneling PCB board uses 5-7kg air compressor without specific cutting place, and it is maintained by wiping its appearance with the anti-rust oil .